How to run the 2D Euler equation code

September 15, 2008, 08:26

I am currently studying the book: Computational Fluid Dynamics: Principle and Application, by J.Blazek.

I would like to know the ways to run the code: "struct2D" given in the CD attached with the book.

I have opened a project, then add all the file in "src" into the project.

When it is compiled and built, there is no error.

When it is run, it appears only the phrase: "SOLUTION OF 2-D EULER/NAVIER-STOKES EQUATIONS ON STRUCTURED GRIDS, J. Blazek, Version 1.5 from Dec" on the command windows. The execution suspend from this event.

I didn't see any selection for inputing the parameters later on.

Please give me a help Thank you in advance

September 30, 2008, 12:53

Hi,

Can you provide me the codes, I can have a look and advice you on it. If your can provide me the airfoil and cascade grid generator it will be nice.

Thanks

Apurva

gchnhn · November 3, 2011, 04:32

but it's not the program's fault
look into the code, you will know that it's waitting for you entering some control parameters and file names

September 15, 2008, 08:26	How to run the 2D Euler equation code	#1
Khanh Guest Posts: n/a	I am currently studying the book: Computational Fluid Dynamics: Principle and Application, by J.Blazek. I would like to know the ways to run the code: "struct2D" given in the CD attached with the book. I have opened a project, then add all the file in "src" into the project. When it is compiled and built, there is no error. When it is run, it appears only the phrase: "SOLUTION OF 2-D EULER/NAVIER-STOKES EQUATIONS ON STRUCTURED GRIDS, J. Blazek, Version 1.5 from Dec" on the command windows. The execution suspend from this event. I didn't see any selection for inputing the parameters later on. Please give me a help Thank you in advance

September 30, 2008, 12:53	Re: How to run the 2D Euler equation code	#2
A.S. Guest Posts: n/a	Hi, Can you provide me the codes, I can have a look and advice you on it. If your can provide me the airfoil and cascade grid generator it will be nice. Thanks Apurva

November 3, 2011, 04:32	I have the same problem as you do	#3
gchnhn New Member Guo Qinghua Join Date: Sep 2011 Location: Nanjing Posts: 10 Rep Power: 14	but it's not the program's fault look into the code, you will know that it's waitting for you entering some control parameters and file names

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
writing an acoustic code based on FW-H equation, have a question regarding pressure	mrshb4	OpenFOAM Running, Solving & CFD	3	November 8, 2014 20:12
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 06:27
Jacobian of 1D Euler Equation of Gas Dynamics	Simplicity.	Main CFD Forum	3	September 6, 2011 14:12
2d Jameson Euler code	Dayton	Main CFD Forum	5	January 17, 2011 13:18
Convert Euler code to full N-S	Soren	Main CFD Forum	3	June 25, 2002 04:47