Home > Forums > General Forums > Main CFD Forum

sliding mesh with Finite elements or finite volume

Mark Forums Read

Reply

Search this Thread

October 9, 2008, 10:07	sliding mesh with Finite elements or finite volume	#1
tool Guest Posts: n/a	Hi, I am about to start writing a CFD code and would like it to be able to handle sliding meshes and free surface flows. I am at the point where I have to decide about using finite volume or finite elements. Any suggestion or recommended reading would be most than welcome. Thank you

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit problems	Althea	FLUENT	22	January 4, 2017 03:19
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
channelFoam for a 3D pipe	AlmostSurelyRob	OpenFOAM	3	June 24, 2011 13:06
engrid: Internal volume mesh becoming coarser during boundayr layer addition	Arnoldinho	OpenFOAM	1	January 22, 2011 04:31
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

All times are GMT -4. The time now is 13:22.