Adiabatic Flame Temperature

November 20, 2008, 00:40

Hi, do you have any information about adiabatic flame temperature for mix of coal dust and excessive air? Thanks for response!

November 28, 2008, 07:35

Hi You need the NCV or net calorific value for the specific coal dust you want to "burn", the composition of the coal (%carbon, moisture, sulphur and nitrogen, etc). And then the first law of thermodynamics will assist in the rest:Q +sum(mh)_reactants = sum(mh)_products. Most thermodynamic handbooks should have a section on combustion. It involves chemical balance as well from inputs above. Regards Jean

November 20, 2008, 00:40	Adiabatic Flame Temperature	#1
Georg Guest Posts: n/a	Hi, do you have any information about adiabatic flame temperature for mix of coal dust and excessive air? Thanks for response!

November 28, 2008, 07:35	Re: Adiabatic Flame Temperature	#2
Jean van der Merwe Guest Posts: n/a	Hi You need the NCV or net calorific value for the specific coal dust you want to "burn", the composition of the coal (%carbon, moisture, sulphur and nitrogen, etc). And then the first law of thermodynamics will assist in the rest:Q +sum(mh)_reactants = sum(mh)_products. Most thermodynamic handbooks should have a section on combustion. It involves chemical balance as well from inputs above. Regards Jean

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 06:27
reactingFoam: adiabatic flame temperature	rFkhemek	OpenFOAM	2	July 31, 2009 06:42
Enquiry about the flame simulation in rotary kiln	hassanelattar	FLUENT	0	March 25, 2009 07:41
Flame temperature	newbie	Main CFD Forum	0	June 14, 2002 02:38
Combustion Convergence problems	Art Stretton	Phoenics	5	April 2, 2002 05:59