|
[Sponsors] |
Extract solid model of expander from Bladegen |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 19, 2009, 17:24 |
Extract solid model of expander from Bladegen
|
#1 |
Guest
Posts: n/a
|
Stess analysis is needed on a expander was created in BladeGen.
How get the solid model from BladeGen. What i am only getting into Design modeler at is fluid volume. Even if i export as 3D IGES I get the fluid volume only. How get solid volume. Step by step explaini. Thanks to everybody. Zhardou Zhinsky |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How model radiation of both solid wall and fluid£¿ | Harry Qiu | FLUENT | 2 | February 3, 2013 23:04 |
Two phase Eulerian model with variable solid density | ziglat2004 | FLUENT | 0 | September 16, 2011 18:06 |
CFX doesn't continue calculation... | mactech001 | CFX | 6 | November 15, 2009 21:25 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
definition difficulty-->DO radiation model | Harry Qiu | FLUENT | 0 | March 29, 2001 09:19 |