|
[Sponsors] |
January 29, 2009, 09:09 |
Mach number
|
#1 |
Guest
Posts: n/a
|
Sometimes I could not see the choice 'Mach Number' from Contour of Velocity when Contour plotting. It would be very much appreciated if anyone could give me a suggestion. Thank you so much.
|
|
January 29, 2009, 14:13 |
Re: Mach number
|
#2 |
Guest
Posts: n/a
|
Yes, sometime I donīt see either...
They say only the chosen one can see! Ok, you might start telling us what software you are using then we can help you. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 13:55 |
mach number and selection of the fluent solver | turbinesv | FLUENT | 4 | April 24, 2011 01:14 |
Strong oscillation at transonic mach number | martingariepy | FLUENT | 2 | May 12, 2009 12:40 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
how calculate the density in low mach number? | Juhee Lee | Main CFD Forum | 1 | July 31, 1999 16:26 |