|
[Sponsors] |
February 4, 2009, 05:40 |
Divergence detected
|
#1 |
Guest
Posts: n/a
|
Dear friends,
i am modeling the flow pattern in a nozzle. If i choose air(real gas) without energy equation, i can get correct simulation. However, a message(Divergence detected in AMG slover) jumped out even before the first iteration after i chose ideal gas and activated energy equation. I've read the relative articles about 'divergence detected in AMG' but i obtained nothing working in my case. Much appreciate if anyone could supply some suggestions. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Divergence detected in AMG solver: ads-0 | Patrino | FLUENT | 6 | May 12, 2022 03:11 |
Quarter Burner mesh with periosic condition | SamCanuck | FLUENT | 2 | August 31, 2011 11:34 |
Divergence detected when using parallel solver | Phil | FLUENT | 3 | May 9, 2008 08:17 |
user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |
user defined function | cfduser | CFX | 0 | April 29, 2006 10:58 |