|
[Sponsors] |
February 9, 2009, 09:10 |
C/C++ as a compiler in ANSYS
|
#1 |
Guest
Posts: n/a
|
I'm trying to write a subroutine which will be compiled by another program and show results in ANSYS. Now, I know that Fortran can be used as this compiler. However, I don't have a lisence and I don't know it very well. Can C/C++ be used as a compiler instead? Can I write this subroutine in C and then show the simulation, results in ANSYS?
Thanks very much |
|
February 12, 2009, 10:53 |
Re: C/C++ as a compiler in ANSYS
|
#2 |
Guest
Posts: n/a
|
Of course.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Command Line Run for ANSYS | Liaquat | ANSYS | 11 | April 19, 2018 09:49 |
Fluid structure interaction | jnattia | Main CFD Forum | 25 | May 21, 2015 09:16 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
C/C++ as a compiler in ANSYS | Can | FLUENT | 0 | February 9, 2009 09:09 |
Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 01:10 |