 |
 |
 |
|
|
|
[Sponsors] | ||||
Overlapping Named Selection error though every named selection differs from each othe |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 6, 2015, 16:12
|
Overlapping Named Selection error though every named selection differs from each othe
|
#1 |
|
Member
Onur
Join Date: Sep 2015
Posts: 42
Rep Power: 10  |
Hi,
I am working on 3D heat exchanger flow fluid analysis. on photo below I have uploaded is relevant to overlapping name selection that I have never made same named selection in same geometry face/edge/vertex How could it possibly to happen even if I could not give any same named selection? Moreover all tubes have been picked up together and all tubes is intersection to outer region that I make design Thanks in Advance https://imageshack.com/i/paX0frrbp |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| y+ and u+ values with low-Re RANS turbulence models: utility + testcase | florian_krause | OpenFOAM | 114 | August 23, 2023 05:37 |
| Near wall treatment in k-omega SST | Arnoldinho | OpenFOAM Running, Solving & CFD | 38 | March 8, 2017 13:48 |
| [OpenFOAM] Native ParaView Reader Bugs | tj22 | ParaView | 270 | January 4, 2016 11:39 |
| [ANSYS Meshing] Overlapping named selections | enr_venkat | ANSYS Meshing & Geometry | 3 | December 2, 2014 10:28 |
| Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |
Linear Mode
