Tee sweep meshing -- CFD Online Discussion Forums

November 14, 2016, 13:14

Tee sweep meshing

Pawel Zdunek

New Member

Join Date: May 2016

Posts: 20

Rep Power: 9

Hello,
I would like to sweep mesh a tee but i got a problem i don't know how to solve - it looks like the way the topology is merged depends on the way i draw it.

I would like to slice the tee into three pieces (see picture 2), but i cannot make the parts to conform to each other like in a picture 1. In model 2 i cannot apply sweep mesh on the tee's branch and in picture 1 i obviously can (with manual src/trgt). Could anybody help me out with this please?

Attached Images

teesweep.jpg (39.0 KB, 10 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] 3D coil mesh: can't create the volume?	RomainBou	OpenFOAM Meshing & Mesh Conversion	3	July 18, 2016 05:09
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 10:49
[ANSYS Meshing] inflation on the face other than source face of sweep meshing?	jayash	ANSYS Meshing & Geometry	0	April 16, 2014 04:11
inflation with sweep meshing	jayash	FLUENT	0	April 11, 2014 08:46
[ANSYS Meshing] Unwanted bias while meshing a tube with sweep and inflation	rasko	ANSYS Meshing & Geometry	7	July 23, 2012 10:31

All times are GMT -4. The time now is 06:29.