Simulating a Laminar Isothermal Flow in a 2D rectangular Channel

HectorRedal · December 18, 2016, 11:01

Hi

I am simulating an isothermal flow (not taken into account energy equation) in a 2D rectangular Channel.

At the inlet the boundary condition is a uniform velocity inlet (constant). On the wall boundaries there is zero-slip condition.

What I am observing is that the flow along the chanel is not constant. As the flow goes downstream, the flow decreases. At the begining of the channel there is a 1m/s x 1m flow, but at the end of the channel there is a 0.9 m/s x 1m flow.

If I reduce the time step, the flow at the end of the channel tends to 1 m/s x 1m (0.95) but not reaching the inlet value (1).

In my opinion this is not correct. But I don't know if reducing the size of the mesh, this effect will be fixed.

Best regards,
Hector.

FMDenaro · December 18, 2016, 11:41

Check the flow rate, it must be the same at each location... if not, you are solving bad the divergence-free constraint.
The velocity must accelerate at the centerline.

December 18, 2016, 11:01	Simulating a Laminar Isothermal Flow in a 2D rectangular Channel	#1
HectorRedal Senior Member Hector Redal Join Date: Aug 2010 Location: Madrid, Spain Posts: 243 Rep Power: 16	Hi I am simulating an isothermal flow (not taken into account energy equation) in a 2D rectangular Channel. At the inlet the boundary condition is a uniform velocity inlet (constant). On the wall boundaries there is zero-slip condition. What I am observing is that the flow along the chanel is not constant. As the flow goes downstream, the flow decreases. At the begining of the channel there is a 1m/s x 1m flow, but at the end of the channel there is a 0.9 m/s x 1m flow. If I reduce the time step, the flow at the end of the channel tends to 1 m/s x 1m (0.95) but not reaching the inlet value (1). In my opinion this is not correct. But I don't know if reducing the size of the mesh, this effect will be fixed. Best regards, Hector.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Specify mass flow rate for periodic boundary conditions in channel flow	lion1990	OpenFOAM Running, Solving & CFD	1	July 9, 2018 17:46
Plotting Nusselt's number and Flow in a rectangular Channel	yomilayeni	FLUENT	0	October 10, 2015 05:22
Open Channel Flow	ElanMorin	FLUENT	4	February 25, 2015 16:26
Ratio of eddy viscosity to molecular viscosity : Laminar or turbulent flow?	JuPa	CFX	7	September 9, 2013 07:45
Help on laminar oscillatory channel flow [Help needed - Urgent]	Dtkcby	Main CFD Forum	0	March 19, 2011 15:11

December 18, 2016, 11:41		#2
FMDenaro Senior Member Filippo Maria Denaro Join Date: Jul 2010 Posts: 6,768 Rep Power: 71	Check the flow rate, it must be the same at each location... if not, you are solving bad the divergence-free constraint. The velocity must accelerate at the centerline.