|
[Sponsors] |
Importing and mapping CFX pressure onto a structural surface |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 24, 2020, 07:34 |
Importing and mapping CFX pressure onto a structural surface
|
#1 |
Member
HS
Join Date: Sep 2015
Posts: 30
Rep Power: 10 |
Hi,
I ran a steady CFX and linked the solution of the CFX component to the setup component of a static structural system. I highlighted the faces of the inner surface of the structural geometry for the "Geometry" selection and "wall" for the CFD surface selection which are needed for the mapping process. I fixed both ends of the model with fixed support. When I run for the solution it seems to have failed and I get a message that "the number of nodes mapped are 0" but there is no indication as to why. Suggestions? Last edited by amsys; March 27, 2020 at 17:14. |
|
Tags |
fsi, imported load |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FSI Importing Pressure Error | nick.l.thomas | ANSYS | 4 | December 9, 2018 22:15 |
FSI - Importing load (Mapping) | moonomid | CFX | 0 | June 3, 2011 11:33 |
Importing .sfe load files from CFX to Ansys ADPL | Eyezac | ANSYS | 0 | May 14, 2010 18:09 |