Fluid overjump in cells
 

Hello everyone,

I am trying to simulate slump cone test for which I adopted only quarter part of the entire Domain for Simulation. I followed exactly the same way of Dambreak tutorial.

At the end of simulation I can find Fluid(in my case concrete) jumping over cells not filling the cells on the bottom wall which was assigned with alpha boundary as zeroGradient, P_rgh boundary fixedFluxPressure and U boundary as fixedValue. The jumpover of Fluid in my case is as shown in figure attached.

I believe numerical schemes and solvers have to changed. I tried many but same problem. Can any one help me to sort out this Problem?

Thank you.