|
[Sponsors] |
April 20, 2018, 11:26 |
*INITIAL CONDITIONS, TYPE=STRESS error
|
#1 |
New Member
Wexford
Join Date: Apr 2018
Posts: 1
Rep Power: 0 |
Hi, I am new to Calculix and GMSH.
I am using GMSH and Calculix to simulate the lattice mismatch stress between Silicon & Silicon Germanium. The difference in lattices is 4.2%. I am trying to apply this as an initial stress at the interface between the 2 materials. I am trying to use the Initial Conditions command. *INITIAL CONDITIONS, TYPE=STRESS interface,1,4.2% I get error reading *INITIAL CONDITIONS Any advice/guidance appreciated regarding the correct manner to do this. Regards, Barry. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Compiling dynamicTopoFvMesh for OpenFOAM 2.1.x | Saxwax | OpenFOAM Installation | 25 | November 29, 2013 05:34 |
[swak4Foam] installing funkySetFields | igo | OpenFOAM Community Contributions | 1 | November 20, 2012 20:16 |
Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit) | Yogini | Fluent UDF and Scheme Programming | 7 | October 3, 2012 07:24 |
ParaView for OF-1.6-ext | Chrisi1984 | OpenFOAM Installation | 0 | December 31, 2010 06:42 |