Home > Forums > General Forums > Main CFD Forum

DesignModeler error during point extraction for TurboGrid

Mark Forums Read

Reply

Search this Thread

August 13, 2018, 15:16	DesignModeler error during point extraction for TurboGrid	#1
dinolsky New Member Dion Join Date: Dec 2014 Location: Bremen, Germany Posts: 13 Rep Power: 11	Hello Everyone, I am trying to extract points from an existing geometry of Impeller in order to create my mesh from Turbogrid. But I am getting this error Code: Error: An internal error has occurred. The bounding box evaluation for the contours failed. Does anyone has experienced this before?. Any suggestion will be highly appreciated. Regards, Dion

Reply

Tags

ansys 18.2, design modeler, turbogrid

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
matching variable data with grid point data	anfho	OpenFOAM Programming & Development	0	May 6, 2011 15:28
CFX Post: Problems with moving point cloud for changing time steps	spatialtime	CFX	0	December 7, 2009 04:56
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 07:36
[Gmsh] Gmsh and samplesurface	touf	OpenFOAM Meshing & Mesh Conversion	2	December 10, 2007 02:27
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

All times are GMT -4. The time now is 19:24.