 |
 |
 |
|
|
|
[Sponsors] | ||||
September 30, 2018, 04:01
|
|
#41 | |
|
Senior Member
Filippo Maria Denaro
Join Date: Jul 2010
Posts: 7,067
Rep Power: 75  |
Quote:
Good, of course you could still check separately the spatial accuracy by using a very small time step and changing the spatial grid size. However, the real accuracy slope is defined by using a constant cfl and tending h, dt simultaneaously towards zero. |
||
|
|
||
 |
| Tags |
| convergence check, runge kutta method, time accurate |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 12:08 |
| simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 03:20 |
| PimpleFoam: check for convergence within time step | Begineer | OpenFOAM Running, Solving & CFD | 3 | April 21, 2014 18:42 |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 16:33 |
| critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 04:01 |
1Likes
Linear Mode
