|
[Sponsors] |
October 17, 2018, 09:40 |
Related to blade profile simulation?
|
#1 |
New Member
Danish Ahmad
Join Date: Oct 2018
Posts: 2
Rep Power: 0 |
Hello! I am performing simulation on a Kaplan turbine's blade. After importing the profile to Design modeler in Ansys fluent and generating the domain and applying the Boolean command to subtract the Hub and blades from the domain, I get the hub subtracted but the blades still showing there, whereas the command is applied properly showing "green colored Ready" in the bottom. How come?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Optimizing blade profile | swapna kondaveeti | CFX | 3 | April 6, 2016 14:18 |
export velocity profile and import in an other simulation as initial condition | FFD | STAR-CCM+ | 4 | February 5, 2016 07:27 |
Blade Generator: How to use Design Profile & Trim Profile | Stabum | CFX | 2 | July 31, 2015 13:01 |
velocity profile export from a simulation onto another | sudhirlv | STAR-CCM+ | 1 | September 12, 2010 18:57 |
Compressible turbine blade simulation | Amisa | CFX | 4 | December 2, 2007 04:13 |