|
[Sponsors] |
February 6, 2020, 04:32 |
Non-manifold bodies error
|
#1 |
New Member
Mehak Shafiq
Join Date: Jan 2020
Posts: 12
Rep Power: 6 |
Hi
I am generating an enclosure around the attached geometry but Design Modeler shows an error: operation would result in non-manifold bodies. Can anyone please help? Regards, Mehak |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit) | Yogini | Fluent UDF and Scheme Programming | 7 | October 3, 2012 07:24 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |