|
[Sponsors] |
March 14, 2020, 09:56 |
Numeca C-Wizard problem
|
#1 |
New Member
Stefano
Join Date: Aug 2019
Posts: 5
Rep Power: 6 |
Hello,
i have terminated all the tutorial. i try to execute a ship resistant calculation with my 3D Rhino model exported in .x_t. i launch C-wizard, mesh and at the end i obtain: Displ., G coordinate --> 0 in all values. However, Domhydro return me, correct values of ship. subsequently, during the "body and frme body motion", i obteined a warning: "the value should be strictly positive". what is my mistakes? thank you in advance |
|
March 15, 2020, 03:31 |
|
#2 |
New Member
Stefano
Join Date: Aug 2019
Posts: 5
Rep Power: 6 |
today, i have by-pass the warning with the estimate values obtained in the body motion.
i start the simulation and, in serial mode, it crash with this error: * Dim_refine: allocated memory too low Less than 5% refinement possible Allocated cells : 500000 Max cells existing grid : 625748 Increase available memory (max. number of cells par partition) Stop what is the reason? thank you in advance |
|
March 21, 2020, 13:53 |
|
#3 |
New Member
Stefano
Join Date: Aug 2019
Posts: 5
Rep Power: 6 |
sorry my friends.
Nobody can help me? thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NUMECA Problem about Parallel Partitioned Computation | Gone | Fidelity CFD | 2 | December 20, 2019 02:33 |
BuoyantBoussinesqSimpleFoam_Facing problem | Mondal131211 | OpenFOAM Running, Solving & CFD | 1 | April 10, 2019 19:41 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |