|
[Sponsors] |
February 20, 2021, 16:11 |
Poor heat transfer in CHT
|
#1 |
New Member
Jakub
Join Date: Feb 2021
Posts: 1
Rep Power: 0 |
Hello,
I'm doing FSI simulation using Abaqus CFD and Abaqus Standard modules. Boundary condition: fluid inlet velocity = 6 m/s fluid inlet temp = 293K outlet pressure = 3bar solid and fluid initial temperature = 1100K No slip on solid part in CFD module. After 60 seconds of simulation temperature dropped by only 20K. I know from data, that temperature should be lower by 70K. I already checked material properties few times. I have no idea what I do not include in the simulation Thanks in advance |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about solid part of CHT (conjugate heat transfer) in CFX | Anna Tian | CFX | 26 | November 15, 2023 12:28 |
Solver for Multispecies Mass Transfer induced Domain growth/shrinkage | MonoC | OpenFOAM Running, Solving & CFD | 1 | March 13, 2016 07:41 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
additional variable mass transfer in CFX5.6 | john | CFX | 1 | February 14, 2004 00:30 |