ANSYS MESH ( Needed for Fluent)
 

I am using a curvature mesh in ANSYS WORKBENCH. I am using Body sizing to control the size of the elements, is this correct ? I need to adjust the element size for my fluent model, however I am not sure if I changing the body size is truly correct. I have changed the Max Tet Size & Min Size but I am not getting good results and therefore I think that changing these values are not as simple as it may seem. In summary, can someone verify that changing the element size using body sizing is correct for a curvature mesh ? :confused::confused::confused::confused:

The reason that I am changing the element size is to evaluate the results for a transient analysis of a flow through a curved pipe.