 |
 |
 |
|
|
|
[Sponsors] | ||||
May 28, 2021, 18:35
|
InterFoam to Model Water Flow
|
#1 |
|
New Member
NA
Join Date: May 2021
Posts: 2
Rep Power: 0  |
Hi Foamers.
I'm pretty new to OpenFOAM. I have spent almost three weeks to setup a simple model using a model created snappyHexMesh. What I'm trying to do is simulate water flow over grading control object depicted by the block mesh. When I run this model, I don't see water is flowing from inlet to outlet on the grading control object. Instead, I see water flow on the wall. I have researched to resolve this issue, but I couldn't. Can you please help me? Thank you. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OpenFOAM - Apparently "not conservative" flow rate with interFoam | foamF | OpenFOAM Running, Solving & CFD | 4 | September 4, 2019 16:02 |
| interFoam wave propagation and explosion of Courant number and residuals | ChiaraViola | OpenFOAM Running, Solving & CFD | 1 | June 26, 2019 06:36 |
| model the sediment flow in moving water pipe | kikoka | OpenFOAM Running, Solving & CFD | 0 | April 4, 2019 05:10 |
| Flow water in channel with zero speed | illia | Fluent Multiphase | 0 | March 21, 2018 08:30 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 10:11 |
Linear Mode
