 |
 |
 |
|
|
|
[Sponsors] | ||||
Symmetrical geometry and parameter settings generate asymmetrical mesh in Gmsh. |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 3, 2021, 00:18
|
Symmetrical geometry and parameter settings generate asymmetrical mesh in Gmsh.
|
#1 |
|
New Member
shenjian
Join Date: Sep 2020
Posts: 2
Rep Power: 0  |
I had a 2d symmetrical airfoil and set symmetrical parameters on the upper and lower surface. Then, I generated the 2D mesh in Gmsh, but I found the upper and lower mesh were not symmetrical, but I couldn't find the problem. I appreciate your help.
 I post .geo file to the attached file. |
|
|
|
|
|
| Tags |
| gmsh, mesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1" | GuiMagyar | OpenFOAM Meshing & Mesh Conversion | 3 | August 4, 2023 12:38 |
| [snappyHexMesh] non uniform mesh near the stl object | vava10 | OpenFOAM Meshing & Mesh Conversion | 0 | January 31, 2021 14:41 |
| [snappyHexMesh] snappyHexMesh - geometry does not appear in Mesh | czhongrong | OpenFOAM Meshing & Mesh Conversion | 1 | January 20, 2016 05:26 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
Linear Mode
