 |
 |
 |
|
|
|
[Sponsors] | ||||
December 24, 2021, 04:41
|
Negative initial temperature
|
#1 |
|
Member
hari charan
Join Date: Sep 2021
Location: India,hyderabad
Posts: 97
Rep Power: 6  |
Hello guys,
I am trying to run sloshing tank tutorial case using compressible interfoam solver keeping rhoConst in equation of state for air and water. But i am getting an error negative initial temperature. I tried change relaxation factor and inserting temperature limits to fvSolution. But error same is appearing again and agin. can anyone help me with this? Thanks in advance. |
|
|
|
|
|
December 30, 2021, 00:54
|
|
#2 |
|
Member
hari charan
Join Date: Sep 2021
Location: India,hyderabad
Posts: 97
Rep Power: 6 |
I found the solution.
Thank you. |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Free surface issues with interDyMFoam for hydroturbine | oumnion | OpenFOAM Running, Solving & CFD | 0 | October 6, 2017 15:05 |
| Cannot run the code properly: very large time step continuity error | crst15 | OpenFOAM Running, Solving & CFD | 9 | December 14, 2014 19:17 |
| pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 09:35 |
| SLTS+rhoPisoFoam: what is rDeltaT??? | nileshjrane | OpenFOAM Running, Solving & CFD | 4 | February 25, 2013 05:13 |
| Error while running rhoPisoFoam.. | nileshjrane | OpenFOAM Running, Solving & CFD | 8 | August 26, 2010 13:50 |
Linear Mode
