ICEM correspondence with Meshing

Nima Shah · June 7, 2022, 12:28

Hello,
I have recently done meshing in ICEM and saved an export with some names. Then the solution ws finished and so on.
Now I have opened "Fluent" to read the case and save it as a new case with slight changes.
The question is I am not sure which .msh file was selected when importing to Fluent.
I am going to delete some of the unused .msh files to gather some space for next solutions.
* I am going to use a Cluster to run my simulations and Fluent launcher.

bluebase · June 7, 2022, 17:36

I haven't used fluent in a very long time. So i don't recall if there is a journal-log somewhere which could tell you what has been done to the file.

But as a workaround, i figure, how about using the absolute cell count of your mesh. these are likely not identical with your set of meshes.

Nima Shah · June 7, 2022, 18:45

Quote:

Originally Posted by bluebase

I haven't used fluent in a very long time. So i don't recall if there is a journal-log somewhere which could tell you what has been done to the file.

But as a workaround, i figure, how about using the absolute cell count of your mesh. these are likely not identical with your set of meshes.

Thanks Sebastian. This might work but I guess there should be a more systematic approach.
Regards

June 7, 2022, 12:28	ICEM correspondence with Meshing	#1
Nima Shah New Member Nima Join Date: Apr 2022 Posts: 18 Rep Power: 4	Hello, I have recently done meshing in ICEM and saved an export with some names. Then the solution ws finished and so on. Now I have opened "Fluent" to read the case and save it as a new case with slight changes. The question is I am not sure which .msh file was selected when importing to Fluent. I am going to delete some of the unused .msh files to gather some space for next solutions. * I am going to use a Cluster to run my simulations and Fluent launcher.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 10:49
Meshing a Mixing Plane in ICEM	Will Anderson	ANSYS Meshing & Geometry	2	November 9, 2010 09:16
Meshing a Mixing Plane using ICEM	Will Anderson	FLUENT	0	November 6, 2010 17:08
[ICEM] ICEM meshing problem	xyq102296	ANSYS Meshing & Geometry	6	October 28, 2010 10:09
ICEM meshing question	gsbhatia89	ANSYS Meshing & Geometry	5	June 14, 2010 08:24

June 7, 2022, 17:36		#2
bluebase Senior Member Sebastian Engel Join Date: Jun 2011 Location: Germany Posts: 566 Rep Power: 20	I haven't used fluent in a very long time. So i don't recall if there is a journal-log somewhere which could tell you what has been done to the file. But as a workaround, i figure, how about using the absolute cell count of your mesh. these are likely not identical with your set of meshes.