 |
 |
 |
|
|
|
[Sponsors] | ||||
July 4, 2022, 07:28
|
Post_processing Surface reports
|
#1 |
|
New Member
Vinay Nandurdikar
Join Date: Jun 2019
Posts: 2
Rep Power: 0  |
What's the difference between the following two surface reports for any variables such as velocity or pressure?
1. Area weighted average 2. Standard deviation |
|
|
|
|
|
July 15, 2022, 13:23
|
|
#2 |
|
New Member
Join Date: Jun 2022
Posts: 11
Rep Power: 3 |
Area weighted average is the mean of all values at all points on a surface. Standard deviation is a quantity which describes how much the value at a point differs from the mean value.
|
|
|
|
|
|
 |
| Tags |
| #ansys#fluent#, #cfd-post |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| addressing and loading on non boundary surface in Pre Processor | Sobhan | CFX | 2 | October 23, 2021 14:22 |
| [snappyHexMesh] snappyHexMesh generates not planar surface | krzychu111 | OpenFOAM Meshing & Mesh Conversion | 2 | April 23, 2020 16:38 |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
| free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |
1Likes
Linear Mode
