[GaspA]

Hello foamers,

I have two general questions regarding NCCs in OF11:


1) How can we replace the cyclicAMI (periodic) condition with the following characteristics:

type cyclicAMI;
neightbourPatch XY;
transform rotational;
rotateAxis (0 0 1);
rotateCenter (0 0 0);

Using NCCs? This question because cyclicAMI no longer exists in OF11.


2) I cannot launch a simulation if I execute the 'renumberMesh' command after decomposing the calculation ('decomposePar'), if the calculation contains NCCs ('createNonConformalCouples'). If the 'renumberMesh' command is run before decomposition, it works.Do you know anything about this?

I thank you for your help.

with my best wishes

GaspA

[NotOverUnderated]

Originally Posted by GaspA

Hello foamers,

I have two general questions regarding NCCs in OF11:


1) How can we replace the cyclicAMI (periodic) condition with the following characteristics:

type cyclicAMI;
neightbourPatch XY;
transform rotational;
rotateAxis (0 0 1);
rotateCenter (0 0 0);

Using NCCs? This question because cyclicAMI no longer exists in OF11.


2) I cannot launch a simulation if I execute the 'renumberMesh' command after decomposing the calculation ('decomposePar'), if the calculation contains NCCs ('createNonConformalCouples'). If the 'renumberMesh' command is run before decomposition, it works.Do you know anything about this?

I thank you for your help.

with my best wishes

GaspA

Hi,

I think you should post this question in OpenFOAM forum here: https://www.cfd-online.com/Forums/openfoam-solving/

best regards