CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Main CFD Forum (
-   -   CFD (

Aston Waite October 12, 2000 18:15


I am a new user of the CFD code WIND. Currently I am trying to get started on the PC. However, I do not have and pre and post processor. Do you know of any free pre/post processor for the PC that works with WIND?


Jeff Hank October 13, 2000 11:08


Check out Fieldview's site at They used to offer a special version of Fieldview to WIND users for FREE. I do not know if this is a PC or UNIX version or if the offer is still valid.

Also look at the following site that lists free solvers, meshers, and post-processors:

Good luck.

Jeff Hank

All times are GMT -4. The time now is 06:55.