|
[Sponsors] |
October 14, 2000, 12:01 |
Gas-particle flow turbulence modulation
|
#1 |
Guest
Posts: n/a
|
Dear Sirs,
I would be thankful for your suggestions on the following problem. I would like to analyze turbulence phenomena in gas and particles flow in a closed channel. What I need is a 2-D code that I could use as a basis for the analysis of this phenomenon. The resulting code should be used for the analysis of my experimental data. I am already using a 1-D code with k-epsilon and Reynolds stresses models, but this code is used only for some rough validation. I am not so sure that RANS could be the final approach for the problem at all. Of course, the code should have some sort of documentation and test examples, so that I could understand in a reasonable period of time. I would be glad to supply additional information if my question is not clear enough. Thanks. |
|
October 16, 2000, 05:11 |
Re: Gas-particle flow turbulence modulation
|
#2 |
Guest
Posts: n/a
|
You might like to have look at level 2 or higher of PHOENICS Shareware. I believe its powerful 2 phase solver is what you are looking for. The software is available via cfdSHOP along with the relevant documentation.
The inspection of Applications, Input Libraries and PHOENICS Journals of CFD will help to locate the examples (or, may be, exactly your problem) to start with. Regards Sergei Zhubrin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Turbulence postprocessing | Mohsin | FLUENT | 2 | October 3, 2016 14:18 |
particle, parcel and mass flow rate balance | flybird | FLUENT | 0 | May 24, 2007 10:44 |
heat transfer betwen gas and particle | eri andika | FLUENT | 5 | December 8, 2003 18:42 |
Flow visualization vs. Calculated flow patterns | Francisco Saldarriaga | Main CFD Forum | 1 | August 2, 1999 23:18 |