Home > Forums > General Forums > Main CFD Forum

HEX vs. TET

Mark Forums Read

Reply

Search this Thread

May 9, 2001, 22:09	HEX vs. TET	#1
Selina Tracy Guest Posts: n/a	Even though I like hex meshes, there are several geometry that does not allow hexa. My Q is: Is hex always better that tet in terms of solution?

May 10, 2001, 06:19	Re: HEX vs. TET	#2
Joern Beilke Guest Posts: n/a	have a look at: http://www.cfd-online.com/Forum/main....cgi?read=7026

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] Blockmesh error - 2D scramjet	ishaninair	OpenFOAM Meshing & Mesh Conversion	7	March 18, 2011 01:14
[ICEM] how can i create a consistent transitions between tet and hex? specifically my model?	snailstb	ANSYS Meshing & Geometry	3	March 15, 2010 21:26
Hex versus Tet	Jade M	CFX	1	March 12, 2010 00:41
CheckMeshbs errors	ivanyao	OpenFOAM Running, Solving & CFD	2	March 11, 2009 03:34
poly, hex dom, hex, tet	azmir	Siemens	0	October 31, 2007 20:24

All times are GMT -4. The time now is 08:38.