|
[Sponsors] |
August 8, 2001, 12:09 |
SIMPLE
|
#1 |
Guest
Posts: n/a
|
I am tring to solve for a cavity driven flow using the well known SIMPLE algorithm. As I increase the Reynolds number by an order of magnitude of 10 my velocity at the node just below the top node and at extreme right takes a value higher than the top velocity or the shearing velocity. Is something wrong with my solver or my discretised equations.
|
|
August 8, 2001, 19:26 |
Re: SIMPLE
|
#2 |
Guest
Posts: n/a
|
(1). As the Reynolds number is increased, the boundary layer will be confined to the wall region, and the velocity gradient will increase accordingly. (2). In other words, the mesh has to be re-distributed to get a better resolution. (3). What is the actual Reynolds number you are calculating? and What is the mesh size? and distribution?
|
|
August 8, 2001, 23:06 |
Re: SIMPLE
|
#3 |
Guest
Posts: n/a
|
1)assign delta-t thru stability criteria (CFL, grid Fourier). 2)solve P' eqn well. 3)incorporate cross sweeps (x and y directions) for momentum and P' eqns.
|
|
August 9, 2001, 08:18 |
Re: SIMPLE
|
#4 |
Guest
Posts: n/a
|
Are you using any upwing? If not, it could be the caused of your problems.
|
|
August 9, 2001, 09:42 |
Re: SIMPLE
|
#5 |
Guest
Posts: n/a
|
I am solving for a steady state solution and so not discretising in time. Solving for P correction equation right now I calculate the value of a_e as calculated in the momentum equations and not just the sum of convective and diffusive face at that face. I am looking at a Reynolds number of 4000. And I am using a staggered grid. I am solving for a box of 10cm*10cm*10cm and a 30*30*30 grid size. The problem is that when i solve for guessed velocity for higher Reynolds number my guessed velocity at the one of the nodes becomes higher than the shearing velcoity. Any suggestions as to what I should read for trteating the singularity at the right hand corner. Also should I be needing ghost cells if I use a staggered grid. Thanks
|
|
August 9, 2001, 09:43 |
Re: SIMPLE
|
#6 |
Guest
Posts: n/a
|
If you mean upwind scheme for the interpolation of convetive terms, Yes.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SIMPLE algorithm in 3D cylindrical coordinates | zouchu | Main CFD Forum | 1 | January 20, 2014 17:02 |
How to add correcting pressure equation in SIMPLE of MRFSimpleFOAM? | renyun0511 | OpenFOAM Programming & Development | 0 | November 4, 2010 01:38 |
Making SIMPLE converge faster | Fabio | Main CFD Forum | 4 | April 9, 2006 11:35 |
PISO vs. SIMPLE | benedikt flurl | Main CFD Forum | 2 | April 14, 2005 06:54 |
flow over a 2D cyl using SIMPLE | T | Main CFD Forum | 1 | January 27, 2001 07:32 |