Home > Forums > General Forums > Main CFD Forum

Von Karman Vortex

Mark Forums Read

Reply

Search this Thread

December 13, 2002, 18:12	Von Karman Vortex	#1
Rodrigo Madariaga Guest Posts: n/a	Hello, before I make a model wing to test in my wind tunnel and compare it with CFD results, I want to check out my Turbulence model. I will do this with a simple cilinder. My question is if I should try a time dependant solution because of the von Karman vortex. Are they really important in the surface pressure results? The wind tunnel speed is 30 m/s and the cilinder diameter is 100mm

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
von Karman vortex street. Vortices formation mechanism.	mnvl	Main CFD Forum	1	February 24, 2010 18:53
Are these reverse von karman vortex street?	quarkz	Main CFD Forum	1	August 20, 2009 16:15
wmake compiling Problem with OF1.5	openTom	OpenFOAM Installation	4	May 3, 2009 15:44
Von karman Vortex street	yoshi	Main CFD Forum	6	September 10, 2005 23:09
Von Karman Vortex	Rodrigo Madariaga	FLUENT	1	December 19, 2002 16:07

All times are GMT -4. The time now is 01:01.