how to code wall contact angle?
Hi,
I am working on a multi-fluid flowing (no mixing)inside a channel project. Can anyone point a direction and/or references that show how the wall contact angle is implemented? Thanks! schou |
Re: how to code wall contact angle?
You need to select wall adhesion in Phases Interaction. Then in Boundary conditions, you select wall, set its momentum property, you will see a place to set contact angle. good luck
|
Re: how to code wall contact angle?
Thanks for the response.
But, I am not looking for the steps how to specify contact angle. I am looking for the procedures/algorithm to "code" contact angle in a fortran source code. In other words, how to implement the contact angle function in the source code. |
All times are GMT -4. The time now is 21:04. |