Home > Forums > General Forums > Main CFD Forum

emergent

Mark Forums Read

Reply

Search this Thread

May 26, 2003, 08:47	emergent	#1
ranran Guest Posts: n/a	Dear All I need to set a 3mm thick oblique slab to take data out from fluent emergently. Now I know how to set a plane using mouse to click three points but don't know how to set this slab. Thank you very much for your help.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
emergent! hot to simulate mcvd process ?	stone	FLUENT	5	February 4, 2002 19:35

All times are GMT -4. The time now is 22:22.