Home > Forums > General Forums > Main CFD Forum

solution

Mark Forums Read

Reply

Search this Thread

October 8, 2003, 03:52	solution	#1
adeel Guest Posts: n/a	friends! i have a problem in which "a fluid is flow out from the nozzle section. At very high mass flow rate their is developement of low pressure region in vicinity of the flow . so i have to optimize mass flow rate so low pressure region donot develope. i developed many domains but fail to capture. it is somewhat like internal plus external flow. i require help in developing domain in ansys cfd and get optimize flow rate.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Integrated conjugate heat transfer solver in OpenFOAM	hjasak	OpenFOAM Running, Solving & CFD	172	April 13, 2023 00:42
IcoFoam parallel woes	msrinath80	OpenFOAM Running, Solving & CFD	9	July 22, 2007 02:58
solution singularity	litonx	OpenFOAM Running, Solving & CFD	1	February 21, 2007 01:32
Mesh independent solution	CFX Begineer	CFX	0	October 27, 2002 10:54
Discussion about Mesh independant solution	Seb	Main CFD Forum	13	May 22, 2001 13:37

All times are GMT -4. The time now is 00:11.