|
[Sponsors] |
August 22, 2009, 18:28 |
Couple of questions: please help
|
#1 |
New Member
Join Date: Aug 2009
Posts: 13
Rep Power: 16 |
Hi everyone, new here and fairly new to cfd analysis. My intention is to analyse the flow around a half fuselage and then seperately wing.
My project is not centred around cfd but analysis is required to prove my design is feasible. I am looking for advise and ideas, to get general results: What Clmax, Cp, total pressure, and density to expect? Mesh, what type of mesh? Size of mesh? Angle of attack to set wing? Do I set my density and temperature at sea level or ceiling Do I use Vmax? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Couple of questions: please help | finesse | CFX | 20 | September 23, 2009 19:49 |
couple of questions to Code_Saturne Developers | Ahmed | Main CFD Forum | 2 | May 3, 2009 14:54 |
A couple of questions about GAMG | piotr | OpenFOAM Running, Solving & CFD | 0 | April 23, 2008 08:09 |
Couple of questions in Fluent | Vidya | FLUENT | 5 | July 27, 2006 03:08 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |