|
[Sponsors] |
November 16, 2003, 09:51 |
SIMPLE problem
|
#1 |
Guest
Posts: n/a
|
I have applied SIMPLE scheme to two parallel plate in order to investigate the fully developed flow between these to plates. But I can not increase inlet velocity or vicsosity, because AP becomes zero therefore no answer for system of equations exists. Please help me in solving this problem.
|
|
November 17, 2003, 22:23 |
Re: SIMPLE problem
|
#2 |
Guest
Posts: n/a
|
Increase the length.
|
|
November 18, 2003, 05:45 |
Re: SIMPLE problem
|
#3 |
Guest
Posts: n/a
|
I do not understand the question. Where does Ap become zero? How do you mean when you say you cannot increase nilet velocity and viscosity.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Very simple natural convection problem | Naseem | FLUENT | 19 | December 17, 2020 16:00 |
A simple problem with mfix | joshzrr | Main CFD Forum | 2 | October 31, 2013 04:11 |
Problem with simple if-comparison | sega | OpenFOAM Programming & Development | 3 | September 8, 2009 07:21 |
extremely simple problem... can you solve it properly? | Mikhail | Main CFD Forum | 40 | September 9, 1999 09:11 |
a VERY SIMPLE problem | Andrew MacAulay | Main CFD Forum | 3 | August 23, 1999 10:39 |