|December 1, 2009, 16:31||
How to validate a flow model
Join Date: Nov 2009
Posts: 26Rep Power: 9
Hi, I am writing a CFD code to simulate incompressible and compressible flow. The code is a two Dimensional code in a cuvelinear mesh. variables are u, v, p, w, and T etc. Now I have almost finished the code. I would like to test the accuracy of the code. Could any one provide some information (or some reference papers) about standard validation method for a code.
Last edited by universez; December 1, 2009 at 17:06.
|Thread||Thread Starter||Forum||Replies||Last Post|
|lenght and number of nodes for an orifice meter flow problem - k-eps model||fofo||FLUENT||0||November 15, 2009 04:49|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|How to model flow of centrifugal fan?||Peter||Main CFD Forum||0||April 2, 2008 06:07|
|axial flow around a cylinder -heat transfer model?||Ralf Schmidt||FLUENT||0||March 21, 2006 04:29|
|Laminar flow in species transport model?||Neha Rao||FLUENT||7||February 25, 2006 03:23|