Problem running parallel
 

Hello, good morning,


We have a problem with a simulation we want to run
in parallel mode but a message error appears (enclosed txt), note that we are using Star CCM+.

The pc has two intel xeon processors (4 cores each one) and the
operating system is windows7 (64 bits); we have installated mpich for win 64 at this computer, is
it ok? We think the problem is at the mpi driver or something simmilar, highlight that on
serial mode the simulation works well, but relative slow.

Can you give us some solution?


Thank´s for tour attention.

We remain at your disposition for any doubt.

Best regards,