|February 4, 2010, 19:10||
Join Date: Nov 2009
Posts: 93Rep Power: 9
I'm new to fluent and I'm working on a case with a "U" pipe. I want to predict the pressure drop for a certain mass flow. I have problems with openfoam so I try to run the case on fluent to see where I did wrong with openfoam.
So I'd like to set the static pressure at the inlet & outlet
(I know, fluent has BC to match a mass flow but I'd like to compare results with OpenFoam wich doesn't have this type of boundary conditions so I do it this way)
In openfoam, there is no droplist for the boundary conditions and you can do whatever you want, it won't tell you if you do wrong things.
Here in fluent, I see that I can't set "static pressure" at the inlet but only total pressure and initial gauge pressure.
Why? Is it an error to only give static pressure @inlet & oulet? You absolutly have to set total pressure? Because in openfoam I set static pressure at the inlet & outlet and maybe my mistake is here so I'd like to know ...
I don't know if my question is very clear but thanks for your help!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Impinging Jet Boundary Conditions||Anindya||Main CFD Forum||25||February 27, 2016 13:58|
|symmetry boundary conditions in cfx||lost.identity||CFX||41||May 22, 2013 07:21|
|Problems with boundary conditions for a lowRekOmegaSST turbulence model||cfdmarkus||OpenFOAM Running, Solving & CFD||16||November 14, 2011 05:44|
|Pressure boundary conditions||Lionel S.||Main CFD Forum||1||August 24, 2007 18:03|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|