|
[Sponsors] |
May 6, 2010, 08:09 |
Heat Transfer in a Driven Cavity
|
#1 |
New Member
Join Date: May 2010
Posts: 2
Rep Power: 0 |
Hello everyone!
I´m currently working on the heat transfer simulation of various surface geometries with CFX and a few of the geometries agree quite well with the flow one can find in the lid driven cavity. Now the problem is, that the "standard" 2-eq turbulence models in cfx just won't do the trick (i have a few measurements at hand for comparison) and i´ll probably have to change these. I´m now searching for some papers or advice concerning the heat transfer in such geometries. I was able to find quite some papers concerning only flow or dealing with bouyancy driven flow but i was unable to find any papers concerning forced convection. I found some things by Ooi et al (1998) and the CFX validation report (200x), but the geometrys don´t agree too well with mine, since their hight/width ratio is 0,1/0,2 and the ones i´m dealing with are in the range of 1-2. I´d be glad if there were any suggestions or advice on where to go next. Thanks Th Last edited by Thcfd; May 6, 2010 at 09:36. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Radiative heat transfer with natural convection inside a square cavity | msarkar | OpenFOAM | 1 | January 11, 2010 22:21 |
Convective / Conductive Heat Transfer in Hypersonic flows | enigma | Main CFD Forum | 2 | November 1, 2009 22:53 |
How can I increase Heat Transfer at Domain Interf? | B.Simon | CFX | 3 | October 28, 2008 18:53 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
heat transfer in rectangular cavity.....HELP!!!... | srinath t k | FLUENT | 1 | December 12, 2000 00:43 |