|July 13, 2010, 14:58||
Creating pairs in COMSOL
Join Date: Mar 2009
Posts: 7Rep Power: 10
I am trying to simulate a fuel cell in COMSOL, so I have different subdomains that it is interesting for me to mesh them separately. Then, I have to use pairs and imprints. My problem is summarizing as follows:
- Two subdomains: 1 and 2
- Model A only in subdomain 1 and Model B only in subdomain 2
- A condition that depends on variables from Model B must be specified for Model A in the boundary that separates both subdomains and viceversa.
If I didn't use pairs, there would be no problem because the boundary belongs to the two regions involved. However, if I use pairs I get two different boundaries, one corresponding to the subdomain 1 and another corresponding to the subdomain 2. These boundaries are coupled using the pair option, but it is not active because the two subdomains don't have a model in common, so I have to specify the boundary condition for model A on its corresponding surface and the same for model B. If I try to solve, I get an error because variables from model A donīt exist in subdomain 2.
Does it have a solution, or is it impossible to create pairs in this case?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problems in creating a wedge type mesh||Joscha||OpenFOAM Native Meshers: blockMesh||27||November 3, 2015 12:27|
|Fluent3DMeshToFoam||simvun||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||48||May 14, 2012 05:20|
|Pros and Cons for CFX, CFdesign, COMSOL||Val||Main CFD Forum||3||June 10, 2011 02:20|
|Problems with Meshing: Collapsed Cells||Emmanuel Resch||CD-adapco||1||July 30, 2007 03:02|
|Gerris software installation||mer||Main CFD Forum||2||November 12, 2005 09:50|