|
[Sponsors] |
August 3, 2004, 05:57 |
Setting up the right boundaries
|
#1 |
Guest
Posts: n/a
|
Hello everybody. My problem is: I'm simulation a pipe system after a pump with an outlet of static pressure. I have a fixed pump that I have to use. What kind of inlet boundary should I define with that situation? The pump is not delivering a fixed flow rate or a fixed pressure. Should I define that boundary as a "total pressure"? That value should be quite fixed as the power stays almost the same all the time.
|
|
August 5, 2004, 19:51 |
Re: Setting up the right boundaries
|
#2 |
Guest
Posts: n/a
|
Hi, usually before you select your pump, you should know what is the pump head pressure you need to drive the flow. So you may specify the fixed pump head pressure as the boundary condition.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
Setting Flow/Pressure Boundaries in Floworks | Eran | FloEFD, FloWorks & FloTHERM | 3 | August 11, 2009 04:23 |
LiftDrag utility from v12 to v141 | cfdphil | OpenFOAM Running, Solving & CFD | 2 | December 5, 2007 05:49 |
Ultra high temperature? | bk | Siemens | 2 | July 19, 2005 00:01 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |