|
[Sponsors] |
October 28, 2010, 07:19 |
Simple pipe
|
#1 |
New Member
Marcin
Join Date: Sep 2010
Posts: 8
Rep Power: 15 |
Hello
I'm want to simulate an air flow thru a pipe.. So i have a pipe loaded as complement the "inlet" to this pipe is loaded as a hole. Next BC inflow is set by a pressure p=1.03e3. I m using physics gravity, viscus... Voind initial state is set to p=0.5e3. When i run simulation a dont get any results.. Does anyone done something like that. I know this is very simple but i cant handle it http://img35.imageshack.us/i/piped.png/ TY |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Using a hybrid mesh for a simple pipe | Udio_NT | ANSYS Meshing & Geometry | 17 | October 18, 2012 14:42 |
some weird results about a simple pipe flow: | Ning | FLUENT | 2 | March 11, 2007 13:23 |
Grid Independence problem for simple pipe geometry | chanchala | FLUENT | 13 | November 20, 2003 08:24 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |