Extruder_simulation

jangolobow · June 26, 2009, 04:36

Hello!

I am a new at forum. I would need a simple 3D model of non newtoniam fluid which flow through extruder screw. Is it possible to get a code or a program in program Fortran, Scilab or Mathematica? Or send me a link or an email on jangolobow@gmail.com

Thank you in advance,
Jan Golobow

mr_fluent · June 28, 2009, 20:41

does openFoam not support non-newtonian model like power law etc.
If it does it might be used i guess and is free.

sar_mech · November 12, 2010, 05:19

Dear JANGOL,
I am currently working with the same type of problem,trying to simulate a non-newtonian flow through an extruder using Fluent,it would be helpful if you could let me know was there any development in your case,regarding the boundary conditions for your problem.

June 26, 2009, 04:36	Extruder_simulation	#1
jangolobow New Member Jan Join Date: Jun 2009 Posts: 5 Rep Power: 16	Hello! I am a new at forum. I would need a simple 3D model of non newtoniam fluid which flow through extruder screw. Is it possible to get a code or a program in program Fortran, Scilab or Mathematica? Or send me a link or an email on jangolobow@gmail.com Thank you in advance, Jan Golobow

November 12, 2010, 05:19	Extruder simulatio	#3
sar_mech New Member saravanakumar Join Date: Mar 2009 Location: United Kingdom Posts: 17 Rep Power: 17	Dear JANGOL, I am currently working with the same type of problem,trying to simulate a non-newtonian flow through an extruder using Fluent,it would be helpful if you could let me know was there any development in your case,regarding the boundary conditions for your problem.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

June 28, 2009, 20:41		#2
mr_fluent Member MrFluent Join Date: Mar 2009 Posts: 33 Rep Power: 17	does openFoam not support non-newtonian model like power law etc. If it does it might be used i guess and is free.