where should enter the thermal conductivity, density, and specific heat value of Al a -- CFD Online Discussion Forums

January 25, 2011, 12:59	where should enter the thermal conductivity, density, and specific heat value of Al a	#1
senCFX New Member sendhil Join Date: May 2010 Posts: 11 Rep Power: 15	Hi CFX user, Previously, I was doing solid and fluid domain modelling in my 3-D geometry. I could easily solve the problem. CurrentlyI am attached honey comb structure (considered as a porous media) just below the solids in my 3-D geometry. The honeycomb structure consists of aluminium alloy mesh. I know porosity, and permeability values. In the porous domain , where should enter the thermal conductivity, density, and specific heat value of Al alloy used in the porous section?. Not only flow modelling, heat transfer modelling also i want to do for this porous section. In this case, should i have to use dispersed solid or dispersed fluid? If anyone know about this problem, kindly help me to model. Regards, SEN

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 00:58
Constant velocity of the material	Sas	CFX	15	July 13, 2010 08:56
Concentric tube heat exchanger (Air-Water)	Young	CFX	5	October 6, 2008 23:17
Two-Phase Buoyant Flow Issue	Miguel Baritto	CFX	4	August 31, 2006 12:02

All times are GMT -4. The time now is 15:55.