 |
 |
 |
|
|
|
[Sponsors] | ||||
March 23, 2011, 22:24
|
error in calculating permeability
|
#1 |
|
New Member
MANISH BHATIA
Join Date: Mar 2011
Posts: 2
Rep Power: 0  |
DEAR ALL,
I HAVE DONE SIMULATION OF FLOW AROUND PERIODIC ARRAY OF CYLINDER DIA: 0.00015 m. then i calculated pressure drop using difference in area weighted pressure at inlet cross section and mid point cross section and multiply it by 2. that total pressure drop used for calculating non dimensional pressure gradient. but values are correct only at Re near 20- 30. its value are wrong at both low and higher Re. for ex at re =5 correct value is 14 but i m getting 1.8. and same problem is happening for porosity 0.8, 0.9, 0.92. kindly help 
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems in calculating the fluid traction on the current structure frame in 3D models | fw407 | OpenFOAM Running, Solving & CFD | 0 | August 6, 2008 12:04 |
| Calculating time | thuy | FLUENT | 5 | April 10, 2008 04:23 |
| how to assign directional permeability? | jemteo | CFX | 0 | April 15, 2006 23:56 |
| correct assignment of permeability? | jemteo | CFX | 0 | March 17, 2006 05:34 |
| How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |
Linear Mode
