Setting Pressure outlet boundary for simulation of Radial impeller

Mukund Pondkule · April 5, 2011, 08:07

Hello Everyone,

I am using a C code for simulation of flow field of an radial impeller. The code is an Finite Volume Solver using Simplex Algorithm. The inlet boundary condition is set as mass flow inlet and outlet is using Neumann boundary condition. I am using Laminar and Incompressible flow,Collocated Grid with the option of doing both steady and unsteady simulations.Presently i am using unsteady simulation and i want to effectually change the outlet Boundary condition so that i have a pressure outlet boundary . so i have tried setting it but the flow field changes and it seems giving wrong results. I have tried working some way out but its seems unfruitful. I hope many among you will have some suggestions.

Thank you.

regards

sazabi2001 · April 5, 2011, 09:24

To be honest, I know little about CFD mathematics models. But one thing I learn is, 'open' or 'pressure' kind of outlet may have quite a problem of back flow, convergence and the length of the outlet pipe..

So I gave up thinking so, and put a velocity / flowrate on the outlet, which has an equal amout of flow rate out as the flow rate in... So the model will become like 'blow and suck' pipe thing.

I have not expected any comparison that it will be better or worst in this way, but at least the convergence of the model is not a problem anymore.

April 5, 2011, 08:07	Setting Pressure outlet boundary for simulation of Radial impeller	#1
Mukund Pondkule New Member Mukund Join Date: Mar 2011 Posts: 2 Rep Power: 0	Hello Everyone, I am using a C code for simulation of flow field of an radial impeller. The code is an Finite Volume Solver using Simplex Algorithm. The inlet boundary condition is set as mass flow inlet and outlet is using Neumann boundary condition. I am using Laminar and Incompressible flow,Collocated Grid with the option of doing both steady and unsteady simulations.Presently i am using unsteady simulation and i want to effectually change the outlet Boundary condition so that i have a pressure outlet boundary . so i have tried setting it but the flow field changes and it seems giving wrong results. I have tried working some way out but its seems unfruitful. I hope many among you will have some suggestions. Thank you. regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting Pressure Boundary Conditions in ANSYS CFX Pre	saisanthoshm88	CFX	21	February 22, 2017 16:50
simple model, difficult outlet	Eric	CFX	7	May 23, 2014 08:13
Static pressure boundary condition at outlet	jennz	CFX	4	February 11, 2014 03:29
Turbulent intensity for pressure Outlet Boundary condition	Mohsin	FLUENT	1	April 30, 2010 10:36
Hydrostatic pressure in 2-phase flow modeling (long)	DS & HB	Main CFD Forum	0	January 8, 2000 15:00

April 5, 2011, 09:24		#2
sazabi2001 New Member YongQiang Chi Join Date: Jun 2010 Posts: 14 Rep Power: 15	To be honest, I know little about CFD mathematics models. But one thing I learn is, 'open' or 'pressure' kind of outlet may have quite a problem of back flow, convergence and the length of the outlet pipe.. So I gave up thinking so, and put a velocity / flowrate on the outlet, which has an equal amout of flow rate out as the flow rate in... So the model will become like 'blow and suck' pipe thing. I have not expected any comparison that it will be better or worst in this way, but at least the convergence of the model is not a problem anymore.