Home > Forums > General Forums > Main CFD Forum

Epslon error.

Mark Forums Read

Reply

Search this Thread

April 12, 2005, 09:23	Epslon error.	#1
Samir Guest Posts: n/a	Hello, I am doing CFD analysis of flow through an elbow pipe. Does anyone have an idea as per what is the limit to the finest convergence that could be acheived in such/or any kind of flows. I am acheiving an epslon error (for axial velocity) of 0.4%. Is that good enough as per top quality CFD analysis standards? Thank you much in advance. Regards Samir

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh	gschaider	OpenFOAM Community Contributions	300	October 29, 2014 19:00
c++ libraries and solver compiling	vaina74	OpenFOAM Installation	13	February 3, 2012 18:43
attach/detach (valve opening/closing)	phsieh2005	OpenFOAM Running, Solving & CFD	2	March 21, 2009 06:18
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 21:50
user defined function	cfduser	CFX	0	April 29, 2006 11:58

All times are GMT -4. The time now is 13:48.