Floating point error-invalid number
Would any one know why they appeal the message "Floating point error-invalid number" whenever I try to shown the contour. Thanks so much.
|
Re: Floating point error-invalid number
In particular if there is 1/x and x=0.
|
Re: Floating point error-invalid number
So where should have that problem, do you have any ideas that where it come from?
|
Re: Floating point error-invalid number
Probably bad code. If it's yours, use a debugger to trap the error. If you bought it, report the error to your vendor.
Specifically, if it's your code and it's written in Fortran, check that all your functions/subroutines have IMPLICIT NONE in them. |
Re: Floating point error-invalid number
If this is a commercial plotting package like tecplot make sure you're not passing it results from a failed CFD run. That's the message tecplot spits out when you try to plot results from a run that has blown up.
|
Re: Debugger ? Where can I find it?
Hi Steve,
YOu talking about debugger, where about in Fluent? Please point it out for me, thank you. Huong |
Re: Debugger ? Where can I find it?
If it's Fluent spewing out bad values, send the problem to them. That's why you pay them.
|
floating point error
Quote:
Hi, I have been receiving this messege since long time" floating error" I did contact fluent people and no one is replying to my question. Is there any body who can help me, or is there anyone who can give me the right contact info for fluent people. thanks |
Floating point error
Hello, i am getting floating point error: invalid number. My thesis train moving in tunnel. Can any body help me. My email is sheikhnasir39@gmail.com
thanks |
Floating point error: invalid number
:( hi all, I had same problem in fluent with a difference that my geometry is bended tube and my fluid is petroleum that part of this non-newtonian liquid is evaporate and this is two phase flow model - mixture. I solve this problem by change (x or y direction) vector direction for mixture to Normal boundary in boundary condition menu for inlet and i use adaption to solve this problem. of course some times the ram are fulled when iteration is done or cpu or hardware is weak. for more help or detail go to following links http://cfdonline.ir/forum/showthread.php?tid=119 http://www.cfd-online.com/Wiki/Fluent_FA...void_it.3F good luck dears |
could you fix it Mr Sheikh Nasir ?! i have been working on this error for about 3 months but i could not :(((
|
Could any body here fix this error ? please help me I need it quick , my email : bkianoush@mail.kntu.ac.ir
|
Does any body here can help me ? i really need fix this peoblem
|
Hi HyperNova. Have you fix your problem?
|
Quote:
|
All times are GMT -4. The time now is 16:04. |