|August 28, 2011, 08:32||
Torque valuation on the shaft of a VAWT
Join Date: Aug 2011
Posts: 2Rep Power: 0
I am new in this forum and a to ANSYS thus my question is a very simple one.
I modelled a VAWT (kind of quiterevolution) for a study I am carrying out with the University. One the simulation was ran I have been able to value the torque on the shaft through the calculator function. However I don't know whether the value I have been given is referred to the torque generate by the wind (viscosity, gradient pressure etc) or it takes in account the toque inducted by the three blade (lift and drag). I hope I made clear my doubt.
Thanks to everyone so kind to answer.
|ansys, torque, vawt|
|Thread||Thread Starter||Forum||Replies||Last Post|
|High torque coefficient Cm for Vertical Axis Wind Turbine (VAWT)||tony00||FLUENT||10||March 27, 2017 01:51|
|Torque calculation of 2D VAWT Wind Turbine||Anonymized_JL1||FLUENT||14||September 26, 2013 03:35|
|positive and negative torque forces||Wei-Haur Lam||CFX||0||March 19, 2008 08:45|
|Torque definition||Yali||CFX||2||January 7, 2008 04:13|
|about use macro to compute torque in TASCflow||lancy||CFX||0||June 10, 2003 06:19|